Click Image for more pictures and specifications. Buy 10 per SKU and save 10%.
- Exclusive Product to M4. New version is smaller, brighter, and uses even less power with super efficient Samsung LEDs.
- Comes with both BA15s (Single Contact Round) and T10 (Wedge) base adapters
- Double Aluminum Plates keep the heat away from the back of your fixture and the adhesive tape.
- Very Sticky Foam Adhesive tape is preinstalled. You need a relatively flat 1.25" x 1.25" area to adhere them to.
- Front Aluminum plate is a heat sink for LED longevity.
- 24 Bright Samsung 5630 SMD LED chips pointing right in the direction you need them.
- 10-30v Non-Polarity Circuitry to protect against voltage surges and aging voltage regulators
- Important Information about Lumens and Visual Light Output
This part number is for Natural White 4500k Color. If you prefer Warm White 3200k, choose part number ALPLATE-24-5630-WW, or Cool White 6000k part number ALPLATE-24-5630-CW. See the image below the Specifications for actual color and output pictures.
This LED plate can also be used to replace the LED module in an ITC 69240ppns light fixture
|Calculated Lumens||24x 35lm 840 calculated|
|Visible Light Output||1.5x the visible light as 921 or 1141|
|Amps at 12.8v DC (Fluke Actual)||< 0.11|
|Rated Volts||10-30v DC|
|Overall Length||1 1/4"|
|Overall Width (or diameter)||1 1/4"|
30 Reviews Hide Reviews Show Reviews
Amazing product and exceptional help. We couldn't order a replacement lamp for our RV. It had been discontinued. The bulb in the lamp was not replaceable and the people at M4 suggested this stick on led bulb. It worked perfectly! Thank you M4led.Fabulous customer support.
These worked great above the table in my RV dining room. Bright... but a good natural white. Didn't cause eye strain compared to other lights.
I've ordered from M4Led.com four times. Won't order LEDs anywhere else. I have never had a problem with anything from M4. I generally get the Natural Light which is great inside an RV.
Really brightened up my Motorhome. Relatively easy install to the original 3 wire harness by removing the supplied plug. Could have been easier and 5 star if the wires came out the side instead of the back of unit as this presented more bulk separating the pre glued unit from the fixture.
These bulbs are awesome. We have more light output from 1 fixture than we had with all of the fixtures in our RV combined! The natural white provides a very nice color. They arrived very quickly, only 2 days after ordering. I am very pleased with these lights. I would order again and recommend to anyone.
Good product and fast service. Thanks
the shipment was quick and correct. The lights were installed and all worked well, very bright. No issues.
I am VERY, pleased with this item... and was so happy to get it... I might order a couple more but for now I have the LED Light over the front door and this adapter went into the existing unit I put up a week ago and I'm very happy with the way it looks and the amount of light it produces! Thanks
In 2016 I purchased ten of these same lights and installed 7 of them in the fixtures of my Winnebago View Motorhome. I have since sold the MH and have purchased a Thor travel trailer. I realized I needed energy saving lights and ones that didn't get scorching hot like the 921 lamps do. Initially I ordered the 48 LED version of this plate lamp and installed them. Then I realized I had three fixtures located in areas where I needed LESS light, so I used the three remaining plate lamps and ordered four more of the 24 LED version. They are excellent lamps.
MY ONLY COMPLAINT is that the double sided sticky foam on the back of the new ones is quite thin compared to the ones purchased in 2016. Since the wires exit the back, the thin foam tape does not make good contact on the end where the wires are located. With the thicker foam tape, the wires didn't interfere with the tape laying flat on the surface and adhering. PLEASE GO BACK TO THE THICK FOAM TAPE.
I love the natural white light color. The bluish tint of cool white and the yellow tint of warm white is, to me, annoying. I want good bright light for my old eyes, and I want to distinguish colors accurately, and see clearly which I feel the extremes of the color range (3000K and 5000K) would not be good for.
Finally, despite extensive burn in of the lights, in both the motorhome and now in the travel trailer, I have never had a single LED element fail. Separating the LEDs from the driver circuity has proven to be a very good idea, allowing for cooling of the plate lights.