6" Clear LED Oval Docking or Backup Lamp with Rubber Seal

My docking lights in my 2007 Tiffin Phaeton were old and yellow and not bright at all. These lights were an easy swap and I didn’t even have to replace the wires. They plugged right in and they look great. Very bright.

pretty bright and easy to wire.

Quality lights. The rubber gasket couldn’t be used on my 2004 Tiffin Allegro Bud, but they look and work great with the old gaskets in place.

Lights themselves work good, however the rubber gaskets are Amazon quality (crap). I used my 8 year old rubber gaskets as they were better than the new ones M4 Note: No tech support questions were asked, we found the review. We reached out for more information and there was no response. Most times when a customer has difficulty installing they do not have the gasket flush enough past the barbs (see images) and are not using lubrication (we like Simple Green) to install. It is important to be tight for a secondary seal, and to not use the old gasket as the profile will not be correct. Yep, being told "amazon quality" stings after our efforts, but we are always here before, during, and after the sale for support, please contact us directly.

Was pleased to see the exact wire harness connector that’s on my Newmar Coach. Used the old rubber gasket because it was a better fit. Nice and bright!!

weg

Replace 4 on my camper perfect fit nice and bright Definitely recommend

Very bright. Lights up the key areas when you are backing into a site in the dark. Thank you again for an excellent product. Easy to install.

Overall it is bright, but I was disappointed in how wide beam of light. The LED fixture is flat and recessed which does not allow light to shine to either side. It shines just straight out. My old fixture was oval and round which allowed the light to shine 180 and not just straight out. Its not a wide beam light. The wiring on the plug and my coach did not match i had to switch wires around to get it to light up. M4 Note: Thanks for the feedback. They do spread a little, but as a flat flush mount they won't shoot sideways. If the wiring had to be changed at the RV, it means the RV manufacture hooked up the power and ground backwards originally. Unfortunately this is not uncommon when they are building RVs, and this type of LED needs the polarity correct, so they simple wire correction will resolve the issue as you found.