4" Red LED Round Running and Stop Lamp with seal and harness

One of the best upgrades we did on our 5th wheel. Recently followed our RV in rain and could barely see the lights, but the semi next to it was lit well with LEDS. Went straight to M4LED, as we have received excellent service from them over the years and their lights are long lasting, higher quality. New LEDS in back now, and I can see the RV clearly in the rain! Thank you, M4LED!

Perfect replacement for my 2012 Redwood 5er. Uses same wiring harness so no need to change wires. Rubber outer ring snaps into factory hole and seals around the edged. No mounting screws needed and no sealant needed.

Excellent fit,very very bright

These were a perfect replacement for the stop/tail/turn 4" incandescent lamps on our 2011 Redwood. Although I could have mounted them in the existing red plastic ring, I chose to use the new rubber seals around which I placed clear silicon caulking. The existing wiring harnesses were also a match and used instead of those included with the new LED lamps. These are much brighter than the old incandescent lamps.

Great bright lights!

I found these to be an exact match for our trailer if you want to use the old bezel ring. I used the rubber gasket that came with the lights, I widened the light hole slightly with a Dremel tool, and they worked fine. They were at least as twice as bright as my original lights.

Replaced taillights on 2012 Redwood. Fit perfectly and brighter by far than original lights.

Just replaced 2 regular on my Rampage Toy Hauler ... sweet!!! I'd like to see a seal where the plug attaches, nice but not absolutely needed.