Product Description
A very bright Red replacement tail light or corner for trailers or vehicles. Use Red lights under a Red lens to accentuate and brighten the color. Bright 5630 LEDs are twice as bright as 5050 size LEDs Aluminum cage works as a heat sink to draw heat away from the LEDs, and makes a more robust lamp.
This is a non-canbus light. Canbus is required on some vehicles if the vehicle computer checks for burned out bulbs, or for turn signals (may cause signal to blink rapidly). Trailer lights do not require Canbus LEDs.
If you don't know if you have a heavy duty relay, remove one bulb and turn on your turn signal. If the indicator and remaining bulbs blink at the normal rate, you can use this bulb as is, but if it blinks rapidly this is not compatible. A Load Resistor can also be put in the circuit to cure rapid blink problems.
This works with Standard 3157 Sockets. Does not work with 3157CK sockets. See the images on the difference so you can test the socket.
Total Length - 2 1/8"
Length of Head - 1 7/8"
Diameter - 3/4"
Voltage - 12v DC
Amp Draw 0.40A
Color - RED
Not DOT Certified.
Product Videos
Custom Field
Product Reviews
6 Reviews Hide Reviews Show Reviews
-
Bright Red LED’s
These led’s are extremely bright. Really made our 2015 Winnebago more visible.
-
Perfect
The old club was killing the wires from the heater. Not more with this
-
LED Tail light Replacements
I changed to LED bulbs to brighten up both the tail lights and brake lights. It was an easy swap in our motorhome and the results were exceptional. Friends had suggested replacing the entire light housing and that LED's were not going to be bright enough, but they were wrong. The illumination proved to be "Super Bright" very pleased. Thank you for your help Steve!
-
Good stock replacement.
I bought this light for my 2017 Road King to increase visibility from the rear. It is an economical alternative to the expensive LED tail light unit. Not as bright overall because most of the LED's face sideways, but will work well when I install the brake light modulator. The instant on/off nature of LED's really gets attention. It's well made. M4 Note: Overall the fixture should light up better and brighter. The light comes out the side and should bounce off the reflector in the light to illuminate the entire lens.
-
Good stock replacement.
I bought this light for my 2017 Road King to increase visibility from the rear. It is an economical alternative to the expensive LED tail light unit. Not as bright overall because most of the LED's face sideways, but will work well when I install the brake light modulator. The instant on/off nature of LED's really gets attention. It's well made. M4 Note: Overall the fixture should light up better and brighter. The light comes out the side and should bounce off the reflector in the light to illuminate the entire lens.
-
Love the Leds
As advertised, Installed on my 99 Fleetwood Discovery. Hard for someone to miss my brake lights
